Mountain Off Road BBTJ9799 - Manual (Page 2)

STEP 5:
You will need to remove the coil bracket from the block , the lower Alt. bracket bolt and if equipped the starter
cable retainer bracket. Install the new PS Block Bracket and the Motor mount together, attach the block bracket using
the supplied hardware using loc-tite on the bolts , ( See Figure 5 for bolt locations ). The coil bracket will be rein-
stalled on top of the new bracket ( do not forget the ground wires), The new bracket will also set on top of the Alt.
bracket on the lower forward hole. Do not tighten the bolts yet. Reinstall the motor mount and see check to see if
the motor mount is in the same location as before, if not the block bracket can be moved slightly to realign the mount
to the frame bracket. The DS bracket has a slotted hole for the through hole on the motor mount this is to help align
the mounts side to side. After the alignment is correct tighten the block bracket bolts and the bolts and nut on the
motor mount. Go back and tighten the DS through bolt.
3 OEM Holes
12x.125 metric hole
New Holes 3/8x16
12-.125x30mm
3/8-16x1 3/8-16x1.5
FIGURE 1
FIGURE 2
FIGURE 3
3 OEM Holes
Coil Bracket
ALT. Bracket
Back Hole
Page 2
Depending on your year of TJ you may not have the
bracket attaching to your block as shown. If your TJ
does not have this bracket install the thin spacer be-
tween the block and bracket.
3/8-16x1-1/4
DS Block Bracket Installed