Mountain Off Road BBTJ0006 - Manual (Page 2)

STEP 5: Install the new PS Block Bracket and the Motor mount together, attach the block bracket using the
supplied hardware using loc-tite on the bolts , ( See Figure 5 for bolt locations ). Do not tighten the bolts yet. Reinstall
the motor mount and check to see if the motor mount is in the same location as before, if not the block bracket can
be moved slightly to realign the mount to the frame bracket. The DS bracket has a slotted hole for the through hole
on the motor mount this is to help align the mounts side to side. After the alignment is correct tighten the block
bracket bolts and the bolts and nut on the motor mount. Go back and tighten the DS through bolt.
3 OEM Holes
New Holes 3/8x16
3/8-16x1
FIGURE 1
FIGURE 2
FIGURE 3
Page 2
3/8-16x1 1/4
DS Block Bracket Installed
FIGURE 4
New AC bracket installed