Lukas MSM-2D mobile control module - Manual (Page 15)

15
Service work may only be performed by the device manufacturer or by personnel trained by
the device manufacturer and authorised LUKAS dealers.
For all components, only original LUKAS replacement parts may be supplied in exchange,
as are listed in the spare parts list, because in this way also any required special tools,
assembly instructions, safety aspects, tests absolutely must be taken into consideration
(see also the chapter "Care and maintenance" for more information).
During the assembly work, pay particular attention to the cleanliness of all components
because dirt can damage the rescue equipment!
WARNING / CAUTION / ATTENTION!
Wear protective clothing when making repairs because the devices may be
under pressure even in the idle state.
NOTE:
Always mail the warranty registration card back to LUKAS Hydraulik GmbH.
Only in this way will you have a claim to the extended warranty coverage.
NOTE:
You should always contact LUKAS or an authorised dealer before using externally
supplied couplings.
Repairs 9.
9.1 General
ATTENTION!
Because LUKAS rescue equipment is designed for the highest performance,
only components may be replaced that are listed in the spare parts lists of the
corresponding device.
Additional components of the equipment may only be replaced if:
- You have participated in a corresponding LUKAS service training course.
- You have the express permission of LUKAS Customer Service (by request,
check on the grant of permission. A check is necessary in each individual
case).
9.2 Preventative service
9.2.1 Care instructions
The exterior of the device needs to be cleaned from time to time and the metallic surfaces
need to be rubbed with oil to protect against corrosion.
9.2.2 Functional check
If there are doubts about safety or reliability, a functional check also needs to be performed.