Lukas MSM-2D mobile control module - Manual (Page 10)

10
WARNING / CAUTION / ATTENTION!
Make sure that the connected devices and the connected
accessories are suitable for the max. operating pressure!
Please consult the "Technical data" chapter to find the maximum
operating pressure between hydraulic unit and Mobile Selection
Manifold and the maximum operating pressure between Mobile
Selection Manifold and hydraulic cylinder.
Male
coupling
Female
coupling
Dust caps
Before coupling, remove dust caps, then connect male and female couplings and turn locking
sleeve of the female coupling in direction "1" until the locking sleeve latches. The connection
is then made and secured. Decouple by turning the locking sleeve in direction "0".
The coupling of the devices under pressure is also possible, assuming the connected
equipment is not turned on.
The supplied dust caps must be reattached to protect against infiltration of dust.
6.2 Connecting the monocouplings
The device is connected via mono coupling halves (female and male) to the hydraulic pump
in such a way that they cannot be reversed.
NOTE:
We recommend, when ambient temperatures are low and extension hoses /
hose winders are used, connecting the coupling halves in a depressurised state
because decoupling may otherwise require a very large exertion of force.
WARNING / CAUTION / ATTENTION!
The monocouplings must not be unscrewed and/or the hose lines reversed!