Apple Xserve (Early 2008) DIY Procedure for Xserve RAID Card Battery - Manual (Page 3)

073-1151 Rev. B 3 © 2007, 2008 Apple Inc. All rights reserved.
Removing the Installed Xserve RAID Card Battery
Note: Before removing the Xserve RAID Card, you must remove the following:
All Apple drive modules •
Both power supplies •
Power distribution board cable •
Airflow duct •
Fan array •
Xserve RAID Card •
Power distribution board •
Apple Drive Modules
Press the handle on the front of the drive module so that the handle pops out. Then grasp 1.
the drive handle, and pull the drive module out of the Xserve.
Repeat for all other installed drive modules. 2.
Power Supplies
Pull the handle to release the first power supply and slide it out of the bay. 1.
Repeat for the second power supply, if installed. 2.
Pull the handle to unlatch the
power supply and remove it.