Getting ready, Installing the card – Apple PowerBook Duo Dock (including Duo Dock Plus) User Manual

Page 34

Text mode
Original mode

Getting ready

You need the Duo Dock, a NuBus card, and either a flat-slot or Phillips
screwdriver (depending on the type of screws you see in step 5 under
“Installing the Card”).

If your system is already set up: Turn off, disconnect, and remove all
equipment attached to the dock, but do not unplug the power cord that
connects the dock to an electrical outlet or power strip.

Installing the card

Unlatch the top cover of the dock by pinching the grooved surface just inside the

front opening.

When the latches release, tilt the cover upward slightly (to about a 30° angle) and then lift

the angled cover straight up to remove it.

This

Not This

Chapter 3