Bryant PREFERRED 581J - Manual (Page 3)

3
FEATURES AND BENEFITS
S Single--stage cooling capacity control on 04 to 07 models
S Two--stage cooling capacity control on 08 and 09 models
S SEER up to 15.6
S EER up to 13.0
S IEER’s up to 13.0
S Exclusive non--corrosive composite condensate pan in accordance with ASHRAE 62 Standard, sloping design; side or
center drain
S Gas efficiencies up to 82%
S Induced draft combustion design
S Redundant gas valve, with up to 2 stages of heating
S Pre--painted exterior panels and primer--coated interior panels tested to 500 hours salt spray protection
S TXV refrigerant metering system on each circuit
S Fully insulated cabinet
S Exclusive IGC solid--state control for on--board diagnostics with LED error code designation, burner control logic and
energy saving indoor fan motor delay
S Dedicated 3--5 ton “Low NOx” models available that meet California Air Quality Management NOx requirement of 40
nangram/joule or less. Low NOx models include stainless steel heat exchangers
S Cooling operating range up to 125_F (52_C), and down to 35_F (2_C) standard
S Access panels with easy grip handles
S Innovative , easy starting, no--strip screw feature on unit access panels
S Two--inch disposable return air filters
S Tool--less filter access door
S Belt drive evaporator--fan motor and pulley combinations available on all three phase models
S Electric Drive x13 (5 speed/torque) motor on 04 to 06 models
S New terminal board facilitating simple safety circuit troubleshooting and simplified control box arrangement
S Field Convertible from vertical to horizontal airflow for slab mounting. No special kits required
S Provisions for thru--the--bottom power entry capability as standard
S Single point gas and electric connections
S Full perimeter base rail with built--in rigging adapters and fork truck slots
S Scroll compressors with internal line--break overload protection
S 24--volt control circuit protected with resettable circuit breaker
S Permanently lubricated evaporator--fan motor
S Totally enclosed condenser motors with permanently lubricated bearings
S Low Pressure switch and high--pressure switch protection
S Exclusive IGC anti--cycle protection for gas heat operation
S Solid--state electronic direct spark ignition system
S Flame roll--out safety protector
S Liquid line filter drier on each circuit
S Standard Warranty: 10 yr. aluminized heat exchanger, 15 yr. stainless steel heat exchanger, 5 yr. compressor, 1 yr. parts.
581J