Apple Remote Desktop 2.2 - Manual (Page 61)

Chapter 3 Administering Computers 61
9 Choose Interact > Control.
10 Control the screen of the selected computer and complete the installation process
interactively.
Using ARD With Mac OS X Server’s NetBoot and Network Install
You can’t install Mac OS X on a client using only Apple Remote Desktop. However,
when used in conjunction with Mac OS X Server’s NetBoot and Network Install features,
ARD can provide valuable, time-saving assistance. You can use it to set the startup
volumes remotely, and then further customize the computers after installation.
The following example procedures assume a familiarity with Mac OS X Server’s features,
Network Image Utility, and the command-line operations in Mac OS X.
To install system software using ARD with Network Install:
1 Install and configure Mac OS X on a client computer.
The other client computers will be based on this computer. The client should be
configured with all your desired software, your desired sharing preferences set, an ARD
login, and ARD administrative privileges. It should have DHCP enabled as its network
addressing method. See “Setting Up Client Computers With Mac OS X 10.3 Installed” on
page 32 for more information.
2 Use Disk Utility to create a disk image of the client computer’s hard disk.
You cannot create a disk image from the startup disk. You need to start up from some
other partition before creating a disk image of the computer’s hard disk.
3 Use Network Image Utility to create a Network Install image for Mac OS X Server using
the disk image.
You should have the following parameters set:
• Install automatically on the volume named “Macintosh HD”.
• Don’t prompt.
• The NetBoot image should be named Macintosh HD.
4 Use ARD to copy the AppleScript shown below to the client computers and then run it.
It will set the hard disk name to the name “Macintosh HD” for use with the NetBoot
image. If you have created a volume named “CloneMe,” this script will name that
volume “Macintosh HD.”
tell application "Finder"
if (exists (disk "Macintosh HD")) then
-- Nothing
else if (exists (disks whose name contains "CloneMe")) then
set the name of first disk whose name contains "CloneMe" to "Macintosh
HD"
else
set the name of disk 1 to "Macintosh HD"
end if
end tell