Apple Xserve RAID: Using RAID 1.2 Admin and Disk Utility - Manual (Page 10)

10 Chapter 1 Configuring an Xserve RAID System
Entering Basic Settings for an Xserve RAID System
You can enter or change a number of settings for the Xserve RAID system. These
include:
• System name
• Location of the system and key contact
• Management or monitoring password
• System time synchronization with the monitoring computer or a network server
• Audible alarm on or off; automatic restart after power outage on or off
• Network address configuration
• Fibre channel options for transmission speed and connection type
• Turning drive cache on or off for each array and controller cache on or off (for each
RAID controller)
Changing some settings will cause the Xserve RAID system to restart.
System Identity and Access
You use the Settings window in RAID Admin to add or change most information for
your Xserve RAID system.
To open the Settings window:
1 In the RAID Admin window, click the Settings button.
2 If necessary, enter the management password and click OK.