AEM 30-4350 Tru-Boost Controller Gauge User Manual
Page 6
Page 6
larm: (ALA - 30)
t pressure at which the alarm will activate. When the alarm is
lled to
pring Pressure: (SPr – 2.00)
g pressure(3psi less then your spring). The Tru Boost
ar Graph Full Scale: (FUL – 30)
sweeping LED lights. The LED lights start at 0 psig
oost Setting A: (AXX – A10)
(10%-90%) for setting A. For setting A, the duty cycle
le,
oost Setting B: (bXX – b10)
ycle is displayed as “bXX”.
OTE: While configuring the Tru Boost, the Tru Boost will stay in the
is turned
re
To enter the program menu, hold both buttons down for 2 seconds and release
then th
uge
A
Set the boos
activated, the LED lights flash yellow and the warning light output (grey wire) is pu
ground.
S
Enter the waste gate sprin
will keep the boost solenoid open from 1 psi until boost exceeds the selected value.
This value can be adjusted to reduce lead in boost spikes or reduce spool up time. If
the spring pressure is unknown, a conservative starting value of 5 is suggested.
B
Set the full-scale value of the
and stop at the full-scale value, increasing in 24 equal increments.
B
Set the output duty cycle
is displayed as “AXX”. When setting duty cycle, the gauge will display the current
manifold pressure. When either button is pressed to increase or decrease duty cyc
the gauge will momentarily display the selected duty cycle before returning to manifold
pressure.
B
Same as A, except duty c
N
programming mode until either the run mode is reached, or the power
off. Also, since the Tru Boost does not change run modes while in the
programming menu, the corresponding run mode must be selected befo
entering the programming menu in order to view real time boost changes.
e gauge will display “PRG”. Hold both buttons again for 2 seconds and release
to move to the first option. Push both buttons at the same time to move to the next
option. The order of options is shown in the menu tree below. As a shortcut, the ga
will skip to boost setting A if only the left button is pressed after “PRG” is displayed.