AEM 30-4350 Tru-Boost Controller Gauge - Manual (Page 5)

Page 5
xternal Pressure Sensor
ble of reading boost levels up to 50 psig when using the
optiona r
.
onfiguring the Tru Boost
ser adjustable options. Descriptions of each option, along
with th
isplay Units: (UnI - PSI)
e front of the gauge to change the units displayed by the
cramble Boost: (SCb - 10.0)
ty cycle output. Duty cycle can be set between 10%
cramble Boost Time: (SCr - 0.00)
5.5 seconds) the Tru Boost will output the
ressure Sensor: (SEn - I)
nsor to be used by the Tru Boost. The internal sensor (I)
t
E
The Tru Boost is capa
l external sensor kit. The 30-4351 sensor kit comes with an AEM 75psia senso
and a harness to connect the sensor to the Tru Boost. See Figure 9. Plug the single
row 3-pin connector into the mating connector on the back of the gauge. See Figure 2
Plug the black 3-pin connector into the pressure sensor. In order for the Tru Boost to
read the external sensor, the external sensor (E) must be selected in the pressure
sensor (SEn) option.
Figure 9. 30-4351 Tru Boost External Sensor Kit
C
The Tru Boost has 9 u
e abbreviation and default value for each option shown in parenthesis, are listed
below:
D
Use the buttons on th
gauge. Select from Psig (PSI), Bar (bAr), and Kpg (PAS).
S
Set the scramble boost du
and 90%. The Tru Boost will output the selected duty cycle when the scramble boost
input is grounded.
S
Select the duration of time (0-2
scramble boost duty cycle when the scramble boost input is grounded.
P
Select the pressure se
is used for boost levels up to 29 psig. The optional external sensor (E) is used for boos
levels above 29 psig, up to 50 psig.