AEM 30-3438 Series 2 AEMnet Adapter - Manual (Page 3)

Page 3
REMOVE EXISTING WIRES FROM ECU PLUG(S)
1. Locate a small screwdriver (a precision 1mm wide flathead screwdriver is recommended)
and carefully pry white plastic retainer (this connector is especially difficult to release, so be
patient and don’t use excessive force) using the middle slot in the retainer so it disengages
vertically about 1mm as shown in figures 2 and 3:
Figure 2: Pry in these areas
Figure 3: Lock that has to move up
1mm