J.P. Instruments EDM 930 Primary Pilots Guide - Manual (Page 71)

For Your Safe Flight Page 66
QUICK REFERENCE
Automatic Scan
1. Tap LF .
2. Tap STEP .
Exclude Measurement in
Automatic Scan (toggle)
1. Tap STEP to index to the
measurement to exclude.
2. Tap both STEP and LF to
toggle exclude/include status.
3. Decimal point before
measurement name means it is
excluded from scan.
Change Scan Indexing Rate
1. Hold STEP and LF until the
display shows PROGRAM ,
followed by Refuel ? .
2. Tap NEXT , see Auto Scan
Rate x .
3. Tap PLUS or MINUS to change
the seconds per scan: 0 to9.
Note: 0 disables auto scanning.
4. Tap NEXT until you see
End?Yes, then EXIT to accept
and exit.
Reset USD (Fuel Used)
1. Tap STEP until x USD shown.
2. Hold both DIM and EGT/FF
until .0 USD is shown.
Display Hobbs
1. Hold the LF and DIM buttons
simultaneously.
Download Data in Memory
1. Insert USB Flash Drive into
front USB port on EDM.
2. DOWNLOAD: NEW (latest
flight) or tap CHANGE to see
DOWNLOAD: ALL ( all stored
flights).
3. Tap STEP and wait until
download progress bar
completes and normal display
returns.
4. Remove USB Flash Drive.
Trip Mode (Accumulate Fuel
Used)
1. Hold both STEP and LF until
the display shows PROGRAM ,
followed by Refuel ? .
2. Tap NEXT until you see Trip
Used? No .
3. To accumulate all fuel used,
tap
Yes and see TRIP? Y .
4. Tap left button until you see
End ?Y and tap Yes to exit.