beautypg.com

J.P. Instruments EDM 930 Primary Pilots Guide User Manual

Page 21

background image

For Your Safe Flight

Page 16

Linear Bar Graph Displays

The linear bar graphs are arranged in a
three by three matrix on the right half of
the display. A typical layout is depicted
here (Note: your actual configuration may
vary). Typical functions that can be
displayed are:

Oil temperature

Oil pressure

Fuel pressure

Bus voltage

Amps (charge/discharge shown)

OAT

Fuel flow

Left tank fuel quantity *

Right tank fuel quantity *

* The fuel quantity gauges will not be functional until the fuel calibration process has

been completed.

The range of the bar graphs depends on the programming. Range,
redlines and/or limits are typically set to match the original aircrafts
gauge markings. These are locked for Primary installations, however
non-primary gauges can be user modified, using ‘EDM Config’ which is
currently available through the front panel buttons. Editing of Gauge
Layout requires EDM Software version 1.20.489 or later. Note: Amps
can operate either as a charge/discharge or load meter, depending on
programming. For charge/discharge, the center of the bar is zero and the
top and bottom are maximum charge and discharge, respectively.