Rock-Slide Engineering JEEP JK2 STEP SLIDER - Manual (Page 6)

Installation Instruction RSEI 107
5. Once the harness is positioned in its proposed layout you will need to gain access to the
slider outside the Jeep to power the slider.
6. Starting on the passenger side; locate the drain plug and drill a small hole into it to
allow you to run the actuator wire to the slider.
a. Once the actuator is run to the slider you can put some silicon sealant around
the drilled hole to prevent any elements from entering, but it’s not required
7. Route the actuator wire around the backside of the slider and plug the red/black
connector into the slider.
a. Actuator wire must be wired around the backside of slider so it’s protected from
the elements and will not be severed off during off-road activity
b. Secure wires to minimize slack so they are protected. We recommend zip ties
c. *Optional: The pink/tan wire is used if LED light package is being installed
8. Inside the Jeep route the door sensor wire along the “B” pillar of passenger doorframe;
and using a sticky pad, mount the sensor underneath the door latch.
a. Connect the green/grey wire to door sensor
b. Place a small piece of electrical tape on sensor wire to secure (see below)
9. While moving to the driver side of the vehicle, position the harness so it can neatly be
hidden under the Jeep carpet upon installation completion.
10. On the driver side, drill a hole down into the tub from inside the Jeep to allow the
actuator wire to be connected to the driver side slider.
a. Drill this hole near the slider’s power plug access to avoid any slack in the
actuator wire and for the wires to avoid the muffler piping
b. Route the actuator wire around the backside of the slider so it’s protected from
the elements and will not be severed off during off-road activity
c. Once the actuator is connected using the red/black wire to the slider you can put
some silicon sealant around the drilled hole to prevent any elements from
entering, but it’s not required
d. Secure wires to minimize slack so they are protected. We recommend zip ties
e. Optional: The pink/brown wire is used if LED light package is being installed
11. Continue to route the harness wires along the lower doorframe on the tub; and just like
performed on the passenger side route the door sensor wire along the “B” pillar up the
doorframe and using a sticky pad, mount the sensor below the door hatch.
a. Connect the orange/yellow wire to the door sensor
b. Place a small piece of electrical tape on sensor wire to secure
**Make sure there is NO interference with the driver/passenger seat belt system* *