beautypg.com

Rock-Slide Engineering JEEP JK2 STEP SLIDER User Manual

Page 4

background image

Installation Instruction RSEI 107

8. Lift the slider back into position and attach it to the Jeep using the 5/16” button head

bolts and 5/16” washers.

a. You will be using 6 bolts/washers per side

b. Apply a small amount of anti-seize to the threads of each bolt upon installation

9. On the inside of Jeep remove the necessary plastic side panels and pull back the carpet

along the door sides of the Jeep to expose the bottom tub.

10. From the bottom of the Jeep drill a 7/32” pilot hole up into the tub at the indicated holes

on the bottom of the slider to attach the 3.5” anchoring bolts.

a. You will be using 2 bolts, 4 washers, and 2 nuts per side

11. From the center of the pilot hole, step up the hole size using a ½” bit to create a finish

hole that will be used to install the 3.5” anchoring bolts.

12. Install the 3.5” bolts through the bottom of the slider into the tub of the Jeep putting a

7/16” washer on the outside and inside of the Jeep with a 7/16” nut on the Jeep’s inside.

13. Double check all bolts to verify components and hardware of secured correctly and

securely to the Jeep.

***Please note: Expect some variance in parts that may require you to adjust the

tension of bolts to make parts fit correctly and properly. Once all parts are installed,

we suggest then fully tightening all bolts again to fit securely***

If you have any questions please contact Rock-Slide Engineering @ 435-752-4580