Rock-Slide Engineering JEEP JK2 STEP SLIDER - Manual (Page 5)

Installation Instruction RSEI 107
WIRING HARNESS INSTALL
**Note: The same harness is used for the JK 4-door version **
The additional door sensors are NOT used for the 2-door version
Step Slider Wiring Diagram
Driver Side
Wire Color Passenger Side Wire Color
Front Door Sensor Orange/Yellow Front Door Sensor Green/Gray
Driver LED Light Brown/Tan Passenger LED Light Pink/Tan
Driver Actuator Red/Black Passenger Actuator Red/Black
**WARNING**
REMOVE FUSE FROM WIRING HARNESS PRIOR TO INSTALLATION! CONNECTING
THE HARNESS TO THE POWER SOURCE WITH THE FUSE ATTACHED WILL SHORT
OUT THE WIRING HARNESS
NEVER ALLOW THE DOOR SENSOR TO COME INTO DIRECT CONTACT WITH THE
ACTUATING MAGNET. THIS WILL DESTROY THE SENSOR MAKING IT UNUSABLE
1. Remove the “B” pillar covers on both driver and passenger and driver sides.
2. Roll the carpet back underneath the rear seat to expose the floorboards.
3. Position the control box under the passenger seat.
a. It’s recommended that you mount the control box, but it’s not required
b. Be sure the control box is out of sight and in a secure location so it will not come
into contact with anything or be kicked by a rear seat passenger
4. Plug the harness into the control box and lay the harness wire into position in the Jeep
starting on the passenger side.
a. You will want to divide the harness between the driver and passenger side to get
an idea of how you want to divide and conceal the harness under the carpet