Rock-Slide Engineering JK – VACUUM PUMP RELOCATION - Manual

Installation Instruction RSEI 118
2010-2014 JEEP JK VACUUM PUMP RELOCATION BRACKET
AC-CRL-100
QTY DESCRIPTION
1 Metal Bracket
2 6mm Bolts
4 Wire Connectors
1 Black Wire
1 White Wire
*If any parts listed are missing or damaged please call Rock-Slide Engineering @
435-752-4580 prior to installation
Remove Factory Bracket
1. Remove the pump and bracket from inside of the frame rail.
2. Disconnect vacuum pump hoses and vacuum pump wire from the vacuum pump.
3. Using a 10mm wrench remove vacuum pump from factory bracket.
4. Use a cut off wheel to remove vacuum pump bracket from the inside of the frame rail.
Make sure to remove the entire bracket so that the frame is the only thing left. The
measurement from frame rail to frame rail should be approximately 26 5/8”.