Rock-Slide Engineering PATRIOT SERIES – WINCH PLATE User Manual
Rock-Slide Engineering For the car
INSTALLATION INSTRUCTION RSEI 113
PATRIOT WINCH PLATE
FB-WP-RS
Installation Instructions
1. Remove factory bolts from bottom of frame rails.
2. Insert winch plate. Align holes on winch plate with factory holes on the frame
rail.
3. Using the 7/16’’ washers provided reinsert the factory bolts and tighten.
4. Install winch using the hardware provided from the winch manufacture.
See also other documents in the category Rock-Slide Engineering For the car:
- RIGID SERIES FRONT BUMPER (4 pages)
- RIGID SERIES REAR BUMPER (7 pages)
- TJ FRONT BUMPER (3 pages)
- TJ REAR BUMPER (8 pages)
- TJ CRAWLER FRONT BUMPER (2 pages)
- Step Slider Door Delete Kit (4 pages)
- TJ YJ LJ STEP SLIDER (8 pages)
- JEEP JK4 STEP SLIDER (10 pages)
- JEEP JK2 STEP SLIDER (9 pages)
- RIGID SERIES SKID PLATE (2 pages)
- JK4 SLIDER (4 pages)
- JK2 SLIDER (3 pages)
- Rigid Rack (3 pages)
- TAILGATE TABLE (5 pages)
- TJ WINCH PLATE (2 pages)
- RIDGE FRONT BUMPER BULL BAR LIGHT KIT (3 pages)
- R-SE JK BOMBSHELL KIT (2 pages)
- 3rd BRAKE LIGHT KIT (3 pages)
- Ford Super Duty Step Slider (14 pages)
- FORD VAN STEP SLIDER (5 pages)
- Ford F-250, F-350, F-450 Front Bumper (5 pages)
- Ford Super Duty Rear Bumper (6 pages)
- STEP-SLIDER MAINTENANCE (1 page)
- STEP SLIDER MOTOR REPLACEMENT (4 pages)
- JK – VACUUM PUMP RELOCATION (3 pages)
- PATRIOT SERIES – FRONT BUMPER (4 pages)
- PATRIOT SERIES – REAR BUMPER (2 pages)
- RAPTOR – STEP SLIDER (12 pages)
- RAPTOR – SLIDER (5 pages)
- PATRIOT SERIES – SKID PLATE (2 pages)
- RAPTOR – WINCH PLATE (1 page)
- RAPTOR – SPARE TIRE CARRIER (4 pages)
- TUNDRA SERIES – STEP SLIDER (12 pages)
- RAM STEP SLIDER (13 pages)