Rock-Slide Engineering R-SE JK BOMBSHELL KIT - Manual

Installation Instruction RSEI 117
R-SE JK BOMBSHELL KIT
AX-BS-100-D44
*If any parts listed are missing or damaged please call Rock-Slide Engineering @
435-752-4580 prior to installation.
JK DANA 30 axle. The outer sleeve kit will need some minor trimming to allow for
install.
JK DANA 30 axle. The inner sleeve kit will work as per the instructions.
JK DANA 44. The inner and outer kits will work as per the instructions.
It is easier to install the kit with the axle removed or with the vehicle on a hoist. It is
possible to install the kit with the axle installed in the Jeep, but some welds may be
harder to do without being able to move the housing.
If the housing is assembled or
has the axle seals in place, welds near the differential housing will need to be done
incrementally in order to keep the heat down so the seals are not damaged.
If done
slowly, 1.5”-2” at a time, and cooled in between welds, the seals will be fine.
Installation of the inner sleeve kit
1. Remove the necessary hardware to allow the inner sleeve to slide over the
axle.
2. Pre-drill ½” holes in the axle housing prior to installing the inner sleeve kit. Drill
approximately 10-15 holes in appropriate places to allow a plug weld to take