Jk oversized tire mount – Hyline Offroad JK OVERSIZED TIRE MOUNT User Manual
Page 2
JK Oversized Tire Mount
Step 1 – Using the Lug Wrench remove the stock tire from vehicle. You will NOT be removing the Stock Tire
Carrier from the Jeep.
Step 2 – If you’re installing a 2” Round LED Third Brake Light you can cut the existing brake light wire and splice
following the light manufacturers instructions. If you’re not installing a Third Brake Light you can leave
the wire as is.
Step 3 – Install the Hyline Oversize Tire Mount onto the existing tire carrier by sliding the existing wheel studs
through the holes of the Hyline Tire Mount and use 3 supplied flat washers and nuts to install.
Step 4 – You can now mount your new oversize tire onto the Hyline Tire Mount. We’ve already pre-installed the
wheel studs so you don’t have to. You may reuse your Lug Nuts.
Step 5 – If installing a 2” Round LED Third Brake Light you can do so by first inserting the rubber grommet into
the hole in the center of the Hyline Oversized Tire Mount, then push in the LED Light and wire.
. If we choose any one of your pictures to
be used on our website, We send you a FREE Hyline Offroad T-Shirt.
T:\Hyline Offroad, LLC\Installation Instructions\JK-20OTM\JK-20OTM Installation Instructions.doc
Page 2 of 2
REV 1 12/4/2009
PLEASE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION
Installation instructions provided must be read and followed exactly when installing
product. Failure to do so could potentially result in injury or death of any occupants
in the vehicle. WEAR SEAT BELTS AT ALL TIMES WHEN DRIVING!
Though our products are rugged, they are primarily designed and built to enhance the appearance of the
vehicle and will not protect from death or injury in the event of an accident. Adhere to all vehicle
manufacturers specifications
Attention
IMPORTANT: We do not recommend installing any tire
larger than 35” in Diameter. Doing so may
cause damage to your Jeep’s tailgate hinges.