Hyline Offroad JK LED LIGHT BAR MOUNT User Manual
Page 2
Q:\Hyline Offroad, LLC\Installation Instructions\400.600.100 JK 50'' LIGHT BAR MOUNT\400.600.100 Installation Instructions.doc
Page 2 of 2
REV 1 9/7/2013
Light Bar Mount Installation
Step 1 – Using Torx Socket remove the 6 bolts in each windshield pillar. You will reuse the
original hardware so don’t throw them away.
Step 2 – Install both brackets with one rubber liner behind each to protect the vehicle’s painted
surface and reinstall original hardware. DO NOT TIGHTEN.
Step 3 – Now install you 50” Light Bar between both brackets. With mounting bracket hardware
still loose you can run the light wiring behind the brackets. This is only one option for
running wires. It is your decision to run wiring in any other way.
Step 4 – After wiring is run you can tighten the torx bolts and light bar hardware appropriately.
Send your OFFROAD pictures to
. If we choose any one
of your pictures to be used on our website, We send you a FREE Hyline Offroad
T-Shirt.
PLEASE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION
Installation instructions provided must be read and followed exactly when installing
product. Failure to do so could potentially result in injury or death of any occupants
in the vehicle. WEAR SEAT BELTS AT ALL TIMES WHEN DRIVING!
Though our products are rugged, they are primarily designed and built to enhance the appearance of the
vehicle and will not protect from death or injury in the event of an accident. Adhere to all vehicle
manufacturers specifications
Attention