Figure 1, Figure 2 – Hyline Offroad TJ STEERING BOX SKID PLATE User Manual

Page 2

Text mode
Original mode

Steering Box Skid Plate Installation

Step 1 – Remove the lower steering gear box bolt and Bottom Bumper Torx Bolt

(See Figure 1 Arrows)

Step 2 – Hold skid plate in place and re-install steering gear box bolt and Torx

bolt in bumper.

Step 3 – With skid plate bolted in place, Use 23/64” Bit to drill a hole through

the frame crossmember tube. This hole is undersize to accept the
self threading 3/8” bolt. (See Figure 2 Arrow)

Step 4 – Use the 9/16” Socket to install the 3/8” self threading bolt by

applying pressure to the head of the ratchet while tightening
bolt. Using the drill with a 9/16” socket adapter bit would make the self threading bolt easier to install.

T:\Hyline Offroad, LLC\Installation Instructions\TJ-40SSP\TJ-40SSP Installation Instructions.doc

Page 2 of 3

REV 1 12/4/2009

PLEASE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION