Connecting the power supply leads, cont’d – PureFlow AirDog FP-150 - Dodge Cummins 1989-1993 User Manual
Page 20
20
PureFlow AirDog
AirDog® 100 & 150
Dodge Cummins 1989 - 1993
Section 6 Electrical Harness
Connecting the power supply leads, cont’d!
6-4B. Should you choose to connect the power supply leads directly to the battery,
connect the RED (+) lead to the POSITIVE (+) post of the driver's side battery.
Connect the BLACK (-) lead to the NEGATIVE (-) post of the same battery.
Black (-) Red (+)
Figure 57
6-5.
Route the wiring harness to the AirDog
®
and connect the 2 pin Deutsch connector to
the corresponding connector on the AirDog
®
.
Figure 58
NOTE: If the Optional Indicator Light is not used, secure the pressure switch lead to the
wiring harness with a plastic tie. Also, cover the pressure sensor lead to protect it you may
want to use it later.