PureFlow AirDog FP-150 - Dodge Cummins 1989-1993 - Manual (Page 19)

19
PureFlow AirDog
AirDog® 100 & 150 Dodge Cummins 1989 - 1993
Section 6 Electrical Harness
Connecting the AirDog
®
Relay Control to the Fuse Panel
6-2. Route the red, Relay Trigger, wire, with the mini fuse
tap attached, to the fuse panel. Insert the mini fuse tap
into a spare fuse holder on the panel that is “hot”
when the starter key is turned to the on position.
Figure 53
6-3.
Route the AirDog
®
pump motor lead to the AirDog
®
.
Connect the 2 pin Deutsch connector on the end of the
wiring harness into the corresponding pump motor lead
connector on the AirDog
®
.
Figure 54
NOTE: The power supply leads can be connected to the battery or the alternator.
Connecting the power supply leads to the alternator instead of the battery
will create a corrosion free connection.
Black (-) Red (+) Replace the Protective Cover
Figure 55 Figure 56
6-4A. Route the Red & Black power supply leads to the alternator Connect the Black (-) lead
to the alternator Chassis Ground connection. Connect the Red (+) lead to the
alternator Hot Lead going to the battery.