BNC 835-3 User Manual - Manual (Page 33)

Continues
Figure 26 Trigger submenu.
Trigger Slope
Retrigger (on/off/immediate) Trigger delay
Select SOURce: IMMediate, EXTernal, BUS (SCPI command), KEY (RF on/off
button) Select SLOPe: POSitive, NEGative
Select CONTinuous: ON, OFF (ON means that the trigger is re-armed after each
trigger occurance)
Select RETRigger: OFF, ON, IMMediate (OFF means that any trigger event during
execution of list is ignored)
Enter DELAY: trigger delay in microseconds.
Press the RF On/Off button to arm the trigger. Exit the menu by pressing the
menu key .
LF OUTPUT Submenu
In the LF OUTPUT Submenu the FUNCT OUT output at the rear panel of the instrument
can be configured.
Press the RF On/Off button to turn the output on and off. Exit the menu by pressing
the menu key .
On the first screen the source for the FUNCT OUT can be selected. Choose LFG for the
low frequency generator, TRIG to enable the internal trigger output, and PULM to enable
the pulse video output. If LFG is selected, use the
↓ arrow to proceed to the second
display. Select waveform between sine, triangle, or square. Then enter the desired
output frequency and voltage amplitude.
33