Displayed parameter formats, Cw display – BNC 835-3 User Manual User Manual
Page 25

Rotary knob
Varies the value at a cursor position (maked by the “_” symbol). Moves the
entry cursor within the various submenus.
Menu Key
This is a multifunction key. The key is used to enter and leave all the
submenus displayed on the screen.
↓ ↑ → ←
Keys
These keys are used to move cursor within the screen menus.
LAN LED
illuminates as soon a remote connection via LAN is active.
Power LED
illuminates when system is powered up.
Displayed Parameter Formats
This section describes how to edit the frequency and amplitude and how to invoke the
remaining functions of the 835-3-HC in local mode.
CW Display
The Main or CW Display is shown after the instrument has successfully booted and is
ready. The four line display has the following format:
Frequency
Power
Ref. Frequency
IP Address
The currently active display position is shown by the cursor (underline symbol). The
cursor does not move beyond the field of the currently selected parameter. Rotate the
front panel knob to modify the value. Clockwise rotation increases the parameter and
counter-clockwise rotation decreases the parameter. The parameter value will continue
to increase or decrease by the amount of the selected resolution until it reaches the
maximum or minimum limit of the parameter.
Use the up and down keys (
↓ ↑
) on the front panel to switch between frequency and
power. Use the left and right arrow keys (
→ ←
) to select the active digit. The resolution
step size is selected by positioning the cursor at the appropriate digit and then turning
the front panel
rotary knob
.
25