Fast & Fluid Galileo Automatic Mixer - Manual (Page 31)

FAST & FLUID MANAGEMENT
A Unit of Idex Corporation
Galileo
31
12.8. Lubrication of the unblocking lever and shafts of the trolley.
Preparation of the machine
 Close the door and switch on the machine
 Close completely the basket plates
 Open the door and switch off the machine
 Turn manually the basket of half a turn
 Push the lever, take out the trolley and block
it.
Blocking lever gear and shafts for taking out the trolley
Grease the lever and slots with a brush
Grease the shafts of the trolley using a
brush Move the trolley and repeat the
operation on previously covered part of
the shaft
12.9. Check of the rubber disks
Preparation of the machine Check of the rubber disks
 Close the door and switch on the
machine
 Open completely the basket plates
 Open the door
 Take out the trolley
 Clean the plates (see paragraph
12.3)
Verify that the inferior disk hasn’t deep
grooves or it is excessively worn Verify that the upper plate hasn’t deep
grooves or it is excessively worn
12.10. Check of the belts
Preparation of the
machine
Check of the transmission belt of the upper plate
 Close the door and switch
on the machine
 Close completely the
plates of the basket
 Open the door and
switch off the machine
Using a key of 8 mm. remove the four screws of the
protection which cover the toothed belt and remove it.
 Check the toothed belt. It must not
to have broken teeth or grindings
 Assemble the protection in its
original position