Fast & Fluid Galileo Automatic Mixer - Manual (Page 30)

FAST & FLUID MANAGEMENT
A Unit of Idex Corporation
Galileo
30
12.5. Cleaning and lubrication of the crown gear
Preparation of the machine Cleaning of the crown gear Greasing of the crown gear
 Close the door and switch on the
machine
 Open completely the basket plates
 Open the door and switch off the
machine.
 Using a key of 8 mm. remove the
screws of the two protections of the
crown gear.
 Remove the old lubricant and the
residual paints using a cloth (See
paragraph 12.3)
 Put the grease on the crown gear
using a brush
 Turn manually the basket repeating
the greasing on all the crown gear.
 Verify that the grease cover the space
among the teeth .
 Assemble again the two protections
in their position.
12.6. Lubrication of the central triple gear group.

Preparation of the machine Greasing of the triple gear group
 Close the door and switch on the
machine
 Open completely the basket plates
 Open the door and switch off the
machine
 By using an 8 mm key, remove the
screws of the protection of the triple
gear group
 Remove the old grease with a cloth
 Put the grease on the conical gears
using a brush
 Verify that the grease cover the
space among the teeth
 Assemble again the two protections
in their position
12.7. Lubrication of the blocking screws wheel.
Preparation of the machine Greasing of the blocking wheel
 Close the door and enter
in the machine
 Close completely the
basket plates
 Open the door and switch
off the machine
 Using a key of 8 mm.
remove the screws of the
toothed wheel
 Remove the old grease by
using a cloth
 Put the grease on the
toothed wheel using a
brush
 Verify that the grease cover
the space among the teeth
 Assemble again the
protection in its position.