ARB 3415120 - Manual (Page 16)

Last Rev Date: 17 SEPTEMBER 2008 Page 16 of 20 Fitting instructions# 3783312
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING BULL BAR TO VEHICLE
72. With the aid of a lift table or one or more
assistants carefully and safely lift, position
and bolt the bull bar to the mounts using 6
x M12 bolts, large flat washers and spring
washers. Centralise the bar to the front of
the vehicle and adjust height.
73. Fit the cross brace to underside of lower
pan and on top of gussets in mount
brackets. Use M10 x 30mm SEMS bolt
and washer sets, flange nuts but do not
do up tight.
74. Adjust the bar height leaving
approximately 15mm gap between top of
wing angled face and the pinch weld on
bumper.
75. Tighten bar mount M12 bolts
76. Tighten M10 flange nuts to chassis studs
to 56Nm.
77. Then tighten up the long M12 tension
bolts, ensuring that the clevis nut location
slot is positioned correctly over the hole
edge in the chassis, protrusion as shown
is approximately 7mm.
78. Tighten brace bolts.
79. Remove each tow hook bolt in turn, apply
loctite © to threads and tighten up.
80. With access through light aperture in
wing, using the M10 pilot holes in mount
brackets (located up 175mm from bottom
face of bar), drill pinning hole through
uprights on bull bar. Fit M10 screw,
washer set and flange nut and do up tight.
Warning: Drilling operations can result in
flying metal debris, safety glasses should be
15mm gap