Brother mp-21c/cdx - Manual (Page 33)

USER’S GUIDE
2-12
How to Remove the Auto Cut Sheet Feeder from the Printer
1. Open the Feeder Cover and remove the paper.
2. Move the Paper Guide to the left.
3. Fold the wire back in the Auto Cut Sheet Feeder, and close the Feeder
Cover and then tilt the Feeder forwards.
!
Caution
Ensure you move the Paper Guide to the left, otherwise it will cause
damage to the Auto Cut Sheet Feeder.
4. Open the Latches(①) on the rear of the Cut Sheet Feeder by them
forwards and push the Latches(②) on both sides inwards into the sheet
feeder. Remove the Auto Cut Sheet Feeder from the Printer.
Fig. 2-14 Latches
5. Set the Latches on both sides of the Cut Sheet Feeder to the normal
position.
Fig. 2-15 Latches
!
Caution
Treat the Latches carefully so that they do not break.