Brother mp-21c/cdx - Manual (Page 16)

USER’S GUIDE
xii
IMPORTANT - Wiring Information (For U.K. only)
If the power cord supplied with the AC Adapter (for MP-21CDX or option) is not
suitable for your electrical outlet, remove the plug from the mains cord and fit an
appropriate three pin plug. If the replacement plug is intended to take a fuse then fit
the same fuse as the original.
If a moulded plug is severed from the power cord then it should be destroyed
because a plug with cut wires is dangerous if plugged into a live socket outlet. Do
not leave it where a child might find it.
In the event of replacing the plug fuse, fit a fuse approved by ASTA to BS1362 with
the same rating as the original fuse.
Always replace the fuse cover. Never use a plug with the cover omitted.
WARNING - DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL
WHICH IS MARKED WITH THE LETTER ‘E’, BY THE EARTH SYMBOL
OR COLOURED GREEN OR YELLOW.
The wires in the mains cord are coloured in accordance with the following code:
Blue: Neutral
Brown: Live
The colours of the wiring in the power lead of this AC Adapter may not correspond
with the markings which identify the terminals in your plug. If you need to fit a
different plug, proceed as follows.
Remove a length of the cord outer sheath, taking care not to damage the coloured
insulation of the wires inside.
Cut each of the wires to the appropriate length.
Remove a short section of the coloured insulation to expose the wires.
The wire which is coloured blue must be connected to the terminal which is marked
with the letter “N” or coloured black or blue.
The wire which is coloured brown must be connected to the terminal which is
marked with the letter “L” or coloured red or brown.
The outer sheath of the cord must be secured inside the plug. The coloured wires
should not hang out of the plug.