Philips DVDQ50AT99 - Manual (Page 49)

Speaker Settings 49
Allows you to select speaker settings, volume balance and
delay time and to test the speaker settings.
Speaker settings are only active on the Analog Multi-Channel
Output.
1
Press SYSTEM MENU. will be selected.
2
Press 9 repeatedly to select
G
, then press :.
3
Press 9 repeatedly to select Speakers, then press :.
4
Press 8 or 9 to select the speaker you want to adjust.
Select Front L & R (left and right), Center, Surround L (left),
Surround R (right), or Sub Woofer. Your audio system may refer to
the Surround speakers as the rear speakers.
5
After selecting the speaker, press :. Then, press 8 or 9 to
adjust the sound of the speaker.
Press OK to go back and select another speaker. Repeat
steps 4-5 as often as necessary until you are satisfied with
the speaker settings.
6
Press SYSTEM MENU to remove the menus.
Speakers
Front L & R
Center
Surround L
Surround R
Sub Woofer
OK to exit 0dB L 0dB
Z Y d
1en 1en 1 st
s
s
1,6
2-5
• The Dolby Digital licensing
agreement does not prohibit
any particular speaker settings.
Instead, it gives guidelines for
possible speaker settings.
Helpful Hint