Brady 200M - Manual (Page 78)

Appendix A - 240 VAC Power Cord
240 VAC Power Cord
Depending on how the Brady printer was ordered, a power cord
may or may not be included when the printer is optioned for
240 VAC, 50/60 Hz. operation.
If a power cord is not supplied, you will need to obtain one with
the following specifications.
1. The overall length must be less than 3.8 meters.
2. It must be rated for at least 5 amps, 250V
3. The CHASSIS GROUND (EARTH) MUST BE CONNECTED
to assure safety and reduce electromagnetic interference. This
is done by the third wire in the power cord.
4. The plug cap should bear the certification mark of a known in-
ternational safety organization (See Figure A.2).
Figure A.1 AC Power Cord
A
p
p
en
d
ix
A
Figure A.2
A-1