Brady 200M - Manual (Page 44)

FEED Key and CANCEL Key Test
This test prints seven pre-programmed label formats at different
speeds. The printer automatically pauses after each format. The
sequence of label formats is as follows.
Extended Printer Diagnostics
Extended diagnostic tests are available. The maintenance manual
provides the information needed to perform these additional tests.
Battery Replacement (200M Only)
One of the factory-installed options for the 200M is the Battery
Backed-up 256 KB Non-volatile SRAM Memory. The battery
used with this option is a 3 VDC lithium battery.
It is recommended that a qualified service technician replace this
battery since it requires internal access to the electronics area of
the printer. Further information regarding the replacement of this
battery is contained in the Maintenance Manual, Vol. 1: General
Maintenance.
CAUTION: Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type
recommended by the manufacturer. Discard used batteries
according to the manufacturer’s instructions.
Label Format Qty Speed
Left Ribbon Wrinkle Test 20 D
Right Ribbon Wrinkle Test 20 D
C39 Wrinkle Test 20 D
Left Ribbon Wrinkle Test 20 A
Right Ribbon Wrinkle Test 20 A
C39 Wrinkle Test 20 A
Usable Area Test 10 D
Label Format Qty Speed
Head Temperature Test 10 D
Upper Smear Test 10 D
Lower Smear Test 10 D
Usable Area Test 10 A
Head Temperature Test 10 A
Upper Smear Test 10 A
Lower Smear Test 10 A
O
p
er
at
io
n
M-Series User ’s Guide Operation
3-11