Brother P-TOUCH 7500 - Manual (Page 54)

44
Updating the PERSONAL symbol category
You can specify whether symbols continue to be added to the PERSONAL symbol category
(with the older symbols deleted) when the category becomes full (ON) or symbols are no longer
added after the PERSONAL symbol category becomes full (OFF). (The default setting is ON.)
1 Press
g, then Z.
2 Press
l or r until SYMBOL UPDATE is displayed.
3 Press
u or d until the desired setting is displayed, and then press n.
Changing the units of measure
The units used for displaying measurements can be set to millimeters (mm) or inches
(inch). (The default setting is mm.)
1 Press
g, then Z.
2 Press
l or r until UNITS is displayed.
3 Press
u or d until the desired setting is displayed, and then press n.
Displaying version information
This function can be used to display the version information for the P-touch software
and built-in symbol set.
1 Press
g, then Z.
2 Press
l or r until VERSION INFO is displayed.
3 Press
u or d until the desired version information is displayed.
4 Press
n to exit Setup mode.
PT75007600uk.book Page 44 Thursday, July 10, 2008 9:39 AM