Philips SENSEO® Latte Select Kaffeepadmaschine User Manual

Page 27

Problem

Solution

There is some milk left

in the milk container

after brewing a coffee

variety with milk.

1. It is normal that there is some milk left in the milk container after you have

brewed a coffee variety with milk. This extra milk is required to ensure high-

quality frothed milk.

2. Perhaps you filled the milk container beyond the level required for the

coffee variety you wanted to brew.
3. You may have used milk that is not cold enough. If the milk temperature

is above the 8°C, the machine uses less milk. Make sure you use cold milk

straight from the refrigerator (5-8°C).

The coffee varieties

with milk are not hot

enough.

1. It is normal that a coffee variety with milk is less hot than a cup of normal

black coffee, as the milk is heated to a lower temperature to ensure high-

quality frothed milk.
2. You can preheat the cups with hot water to keep the coffee hot longer. The

best way to do this is by pressing the 1-cup button qwithout using a coffee

pod.
3. You may have used cups that are too large, which cause the coffee to get

cold more quickly. We advise you to use a 180ml cup for cappuccino, a 260ml

cup for latte macchiato and a 220ml cup for caffè latte.

The SENSEO

machine

splatters when it brews

a coffee variety with

milk.

You may have used milk that is too warm. Make sure you use cold milk

straight from the refrigerator (5-8°C).

The CALC CLEAN

indicator lights up

continuously.

The CALC CLEAN indicator goes on when you need to descale the

machine. This happens after 1000 cups of SENSEO

black coffee or 250 cups

of cappuccino, latte macchiato or caffè latte have been brewed. To descale

your SENSEO

machine, follow the instructions in chapter ‘Descaling’. The

CALC CLEAN indicator goes out after the descaling procedure has been

performed correctly and the Calc-Clean tool has been removed.

I pressed the CLEAN/

CALC CLEAN button,

but the machine does

not work.

1. If you want to flush the milk container unit, make sure you have filled

the milk container with cold water and you have inserted the milk container

unit properly into the machine.

2. If you want to descale the machine, make sure the Calc-Clean tool is

placed correctly. See chapter ‘Descaling’ for more details.
3. Perhaps the machine is still heating up (the light ring around the on/off

button flashes slowly). The machine needs some time to heat up before

descaling is possible.

The descaling cycle

lasted only 5 minutes.

The descaling cycle was probably interrupted. This can have several causes: 1)

You pressed the on/off button during the descaling cycle 2) You removed the

water reservoir during the descaling cycle 3) You did not place the Calc-Clean

tool correctly or removed it from the machine during the descaling cycle.

EnglisH