B&B Electronics Elinx EIR510-2SC-T - Manual (Page 46)

38
Manual Documentation Number: EIR510-xSFP-T_0708m
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Name]
no snmpv3 mibview
view
[View Name]
type
[Excluded|Included]
sub-oid
[OID]
G Remove specified
mibview table of
SNMPV3 agent.
switch(config)#no snmpv3
mibview view V1 type Excluded
sub-oid 1.3.6.1
Port Mirroring Commands Set
Commands Level Description Example
monitor rx G Set RX destination
port of monitor function
switch(config)#monitor rx
monitor tx G Set TX destination port
of monitor function
switch(config)#monitor tx
show monitor P Show port monitor
information
switch#show monitor
monitor
[RX|TX|Both]
I Configure source port
of monitor function
switch(config)#interface
fastEthernet 2
switch(config-if)#monitor RX
show monitor I Show port monitor
information
switch(config)#interface
fastEthernet 2
switch(config-if)#show monitor
no monitor I Disable source port of
monitor function
switch(config)#interface
fastEthernet 2
switch(config-if)#no monitor
802.1x Commands Set
Commands Level Description Example
8021x enable G Use the 802.1x global
configuration
command to enable
802.1x protocols.
switch(config)# 8021x enable
8021x system radiousip G Use the 802.1x system switch(config)# 8021x system