Brother FAX 275 - Manual (Page 41)

27
I N I T I A L S E T U P
Setting Beeper Volume
You can set the beeper to LOW, HIGH or OFF. The default setting is LOW.
When the beeper is set to LOW or HIGH, the fax machine beeps every time
you press a key or make an error, and at the end of fax sending or receiving.
1 Press Function , 1 , 4 .
2 Press or to select your setting and press Set .
3 Press Stop to exit.
Setting the Handset Volume
Before you begin to use the fax machine, you must decide if you need to set
the handset volume to AMPLIFY:ON for a user who is hearing-impaired.
The AMPLIFY volume level complies with FCC standards.
VOLUME AMPLIFY: OFF
This default setting is appropriate if none of the users are hearing-impaired.
During a conversation, users can press
or on the control panel to
adjust the volume. When the handset is replaced, the handset volume remain
until you change it again.
VOLUME AMPLIFY: ON–TEMPORARY
This setting is appropriate if some of the users are hearing-impaired. During
a conversation, users can press
or on the control panel to adjust
the volume to LOW, HIGH or AMPLIFY. When the handset is replaced, the
handset volume will returns to the default setting of LOW.
VOL AMPLIFY:ON–PERMANENT
Choose VOL AMPLIFY:ON–PERMANENT if all of the users are hearing-
impaired. During a conversation, users can press
or on the
control panel to adjust the volume to LOW, HIGH or AMPLIFY. When the
handset is replaced, the handset volume returns to the default setting of
AMPLIFY.
When you press or on the control panel to adjust the volume, the
display shows the setting you are choosing. Each key press changes the
volume to the next setting.
It is important that you do not choose PERMANENT unless all users
are hearing-impaired. Otherwise, the default setting of AMPLIFY may
damage the hearing of some users.