Blaupunkt FRANKFURT RCM 169 - Manual (Page 39)

88
To delete the name of one CD
•
press CD for approx. 1 sec.
“CD clr” will appear briefly in the top
line of the display.
To delete the names for all of the CDs
•
press ALL for approx. 4 sec.
“Memo clr” will appear briefly in the top
line of the display.
To return to the DSC menu:
•
Press EXIT.
Press EXIT or DSC to quit the DSC menu.
Clock - Time
This car audio system is equipped with a
built-in clock which automatically takes ad-
vantage of RDS to ensure highly accurate
time-keeping (hours, minutes).
For the clock to function properly with RDS,
an RDS station with the CT function (CT -
clock time) must be received.
If this signal is not available, the audio sys-
tem will attempt to receive the DCF-77 time
signal (atomic clock) to correct the time the
next time it is switched off. The display will
indicate “CLK Sync” while it is synchronis-
ing the time.
The automatic time correction feature can
be switched off.
Displaying the clock
You can set the clock to permanent display
in any of the operating modes (radio, tape
deck, CD changer).
To do so
•
Press TU, CC or CDC to select the
operating mode.
• Press DIS repeatedly until the time ap-
pears in the top line of the display.
The clock will now appear in the display as
the main element.
CD changer operation
Clock display when the audio system is
switched off
You can have the clock displayed when the
ignition is switched on, but the audio sys-
tem is switched off. Make the correspond-
ing setting in the DSC menu.
If necessary, refer to the section on “DSC
programming - CLK, VIEW”.
Setting the clock
a) automatically
The clock is set automatically when the
radio is tuned into an RDS station
which has the “CT” function (clock
time).
b) manually with DSC-CLK
It is not necessary to adjust the clock
manually unless it is not possible to re-
ceive an RDS radio station with CT
(Clocktime).
If you would like to set the clock manu-
ally, refer to the section on “DSC pro-
gramming - CLK, SET”.