Blaupunkt FRANKFURT RCM 169 - Manual (Page 18)

67
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
“Training” a second KeyCard /
Replacing a KeyCard
When the unit is in operation with the first
KeyCard, you can “train” a second one to
use with the set as well.
If you want to “train” a second KeyCard:
• Insert the first KeyCard and turn on the
set.
• Press DSC, KC (KeyCard) and LRN
(learn) one after the other.
• Remove the first KeyCard and insert
the new one.
The display will read “Learn OK”.
To exit the menu
•
press DSC.
Now you can also use the new KeyCard for
operating your unit.
A maximum of two cards can be used with
the set.
If you attempt to “train” a third one, the ac-
cess authorisation for the KeyCard not used
for the “training” process will be deleted au-
tomatically.
Incorrect KeyCard
If a wrong KeyCard is inserted, then “Wrong
KC” will appear in the display.
Remove the wrong card and insert the cor-
rect KeyCard.
Displaying the radio pass data
You can use the KeyCard supplied with your
set to display the radio pass data such as
the model name, product number (7 6..) and
serial number.
Please refer to the section on “DSC pro-
gramming - KC (KeyCard), READ”.
Short Additional Memory
(S.A.M.)
The second KeyCard available from your
specialised dealer allows you to read out
short information under the DSC menu item
“KC, READ”. This information will run
through the display and could include, for
example, the phone number of your car re-
pair service or the emergency call number
of your automobile association.
The freely selectable text with a maximum
of 162 characters can be programmed by
any dealer who has the required equipment
available.
Turn On Message (T.O.M.)
The second KeyCard available from your
specialised dealer also allows you to dis-
play a special turn-on message each time
the radio is switched on.
The freely selectable text with a maximum
of 48 characters can be programmed by any
dealer who has the required equipment
available.
Each time you turn on your system with the
second KeyCard, the programmed text will
appear in the display. Important: “TOM on”
must be selected in the DSC menu.
To find out how to do this, refer to the sec-
tion on “DSC programming - KC (KeyCard),
TOM”.
Flashing light as theft protection
Flashing light diode A
When the vehicle is stationary and the Key-
Card has been removed, the light diode can
be switched to flash as an extra anti-theft
device.
For this to function properly, it is necessary
that the positive power supply line and the
permanent +12 V lead are connected as
described in the installation instructions.
KeyCard theft protection system