Blaupunkt FRANKFURT RCM 169 - Manual (Page 34)

83
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Switching Dolby B NR on/off:
•
press DLBY.
* The noise reduction system manufactured under li-
cence from the Dolby Laboratories Licensing Corpo-
ration. The word DOLBY and the double-D symbol
are trademarks of the DOLBY Laboratories.
Selecting the display mode
You can switch the display mode during tape
deck operation to display the tape side or
the clock.
•
Press DIS briefly.
Either the tape counter or Side A/B will ap-
pear in the DOT display.
Track reverse
To change the track during playback:
•
Press REV.
When the tape reaches the end of a side it
will automatically switch to the other side
(autoreverse). “SIDE A” will appear in the
display for track 1 and “SIDE B” for track 2.
Note:
If there is too much tension on the tape while
it is playing, it may switch to the opposite
track before it has reached the end. Check
to see if the tape is wound correctly. It often
helps to rewind the cassette completely.
Scanning cassette titles with
SCAN
It is possible to scan the titles on a cassette.
As soon as you find a title you like, you can
end SCAN. This title will then continue to
play.
SCAN is active when the corresponding red
arrow flashes in the display.
To start/end SCAN:
•
Press SCAN.
To ensure that this function works properly,
there must be a pause of at least 3 seconds
between titles.
The scan time is set to 10 seconds at the
factory and can be altered from 5 to 30 sec-
onds.
If necessary, refer to the section on “DSC
programming - VAR (various), SCAN”.
Selecting titles with S-CPS
(Super Cassette Program Search)
To repeat and skip cassette titles.
/ Select title
Forward (CPS-FF ..)
Rewind (CPS-FR ..)
It is possible to skip up to 9 titles. To do so,
•
press / on the rocker switch as of-
ten as required.
The number of titles to be skipped will ap-
pear in the display.
Make any corrections by pressing the op-
posite key ( / ).
Press REV to stop this function immediate-
ly.
To ensure that this function works properly,
there must be a pause of at least 3 seconds
between titles.
Tape operation