Brother HL-5470DWT User Manual
Page 137
131
Troubleshooting
6
Duplex Disabled
The back cover of the machine is
not closed completely.
Close the back cover of the machine.
The duplex tray is not installed or
not installed correctly.
Re-install the duplex tray.
Fuser Error
The temperature of the fuser unit
does not rise to a specified
temperature within the specified
time.
Turn the power switch off, wait a few seconds, and
then turn it on again. Leave the machine for 15
minutes with the power on.
The fuser unit is too hot.
Jam Duplex
The paper is jammed in the duplex
tray or the fuser unit.
See Paper is jammed in the Duplex tray
uu
Jam Inside
The paper is jammed inside the
machine.
See Paper is jammed inside the machine
uu
The toner cartridge is placed in the
machine without the drum unit.
Put the toner cartridge into the drum unit, and then
re-install the drum unit and toner cartridge assembly
in the machine.
Jam MP Tray
The paper is jammed in the MP tray
of the machine.
See Paper is jammed in the MP tray uu page 134.
Jam Rear
The paper is jammed in the back of
the machine.
See Paper is jammed at the back of the machine
uu
Jam Tray 1
Jam Tray 2
The paper is jammed in the paper
tray of the machine.
See Paper is jammed in Paper Tray 1 or Tray 2
uu
Limit Exceeded
The printing limit set by Secure
Function Lock 2.0 was reached.
Contact your administrator to check your Secure
Function Lock Settings.
Log Access Error
The machine could not access the
print log file in the server.
Contact your administrator to check the Store Print
Log to Network settings.
(For detailed information uu Network User's Guide:
Store Print Log to Network)
Manual Feed
Manual was selected as the paper
source when there was no paper in
the MP tray.
Place the same size of paper in the MP tray as is
shown on the LCD. If the machine is in Pause mode,
press Go. (See Loading paper in the multi-purpose
tray (MP tray) uu page 12.)
No Paper
Load
in
The machine is out of paper or
paper is not correctly loaded in the
specified paper tray.
Put paper in the indicated paper tray.
Make sure the paper guides are set to the correct
size.
No Toner
The toner cartridge or the drum unit
and toner cartridge assembly is not
installed properly.
Remove the drum unit and toner cartridge assembly,
remove the toner cartridge from the drum unit, and
re-install the toner cartridge back into the drum unit
again. Re-install the drum unit and toner cartridge
assembly back in the machine. If the problem
continues, replace the toner cartridge. (See
Replacing the toner cartridge uu page 104)
No Tray
The standard paper tray is not
installed or not installed correctly.
Re-install the standard paper tray.
Error message
Cause
Action