Bunn Dual TF DBC - Manual (Page 31)

Page 31
PROGRAMMING THE BREWER (cont.)
DRIP TIME (now displayed on "non" funnel lock
units as well)
This function allows the setting or modifi cation
of the funnel locks to stay engaged after the end of
a brew cycle. This ensures that the funnel cannot be
removed until after the liquid has emptied out of the
funnel.
Procedure to modify drip times:
Range: OFF to 10 minutes for all three batch sizes.
NOTE: If the brewer is already in the DRIP TIMES
screen, it is not necessary to follow steps 1 through
9 in this section, but proceed directly to step 10.
1. Press and hold the upper right hidden switch until
the display reads UNITS. Release the switch. Press
and release switch until the display reads REVIEW
RECIPES.
2. Press YES to proceed. The display should now
read NO-NAME LEFT, along with MODIFY, SHOW
and NEXT.
3. Press and release NEXT to advance to the desired
coffee name to be modifi ed.
4. Press and release MODIFY. The display should
read BREW OZ.
5. Press and release DONE. The display should read
3 BATCHES DONE?.
6. Press and release YES. The display should now
read % BYPASS.
7. Press and release DONE. The display should read
3 BATCHES DONE?.
8. Press and release YES. The display should now
read SET PULSE BREW.
9. Press and release NO. The display should now read
DRIP TIME, along with either the word OFF, or a
time will be showing. A batch light should also be
blinking.
10. Using the (-) and (+), set the amount of time from
when the brew solenoid shuts off to when drip-out
occurs for that batch size.
NOTE: Set to OFF to prevent funnel locks from engag-
ing (to disable this function), for a particular batch
size. To set to OFF, press and release (-) until OFF is
displayed.