Bunn Dual TF DBC - Manual (Page 25)

Page 25
% BYPASS
This function allows adjustment of the amount of
water that bypasses the grounds. The number signi-
fi es the percentage of the brew volume which does
not fl ow over the coffee grounds.
Modifying recipes - bypass percentages:
Range: 0% to 90% for all three batch sizes
NOTE: If the brewer is already in the % BYPASS screen,
it is not necessary to follow steps 1 through 6 in this
section, but proceed directly to step 7.
1. Press and hold upper right hidden switch until
the display reads UNITS. Release the switch, then
press and release switch until the display reads
REVIEW RECIPES.
2. Press YES to proceed. The display should now
read NO-NAME LEFT, along with MODIFY, SHOW
and NEXT.
3. Press and release NEXT to advance to the desired
coffee name to be modifi ed.
P2292
4. Press and release MODIFY. The display should
read BREW OZ.
5. Press and release DONE. The display should read
3 BATCHES DONE?.
6. Press and release YES. The display should now
read % BYPASS, and a batch light will be blinking.
Press and release the batch size to be modifi ed.
7. Using (-) and (+) set the amount of bypass water
(percentage) to be dispensed around the grounds
for that particular batch size.
8. When fi nished, press another batch size and repeat
step 7 for each batch to be modifi ed.
9. When fi nished setting all batch sizes, press DONE.
The display should read 3 BATCHES DONE?
10. If they are not correct, press and release NO to
return to the % BYPASS setup screen.
11. If the 3 batch sizes are correct, press YES. This will
advance to SET PULSE BREW. Another alternative
is to press either ON/OFF switch located on the
front switch panel to exit the % BYPASS setup
and return to the MAIN SCREEN.
PROGRAMMING THE BREWER (cont.)