Bunn Dual TF DBC - Manual (Page 23)

Page 23
REVIEW RECIPES/MODIFY RECIPES/SET UP NO
NAME COFFEE FLAVORS:
This function has three parts. It allows the operator
to view the brew settings for the various coffee names
programmed into the brewer.
It also allows the operator to modify (change) any of
the BREW VOLUMES, BYPASS PERCENTAGES, PULSE
BREW TIMES, PRE-INFUSION TIMES and DRIP-OUT
TIMES for a particular coffee name programmed into
the brewer.
Finally, this function is used to set up the two NO
NAME coffee BREW VOLUMES, BYPASS PERCENT-
AGES, PULSE BREW TIMES and DRIP-OUT TIMES.
Procedure for reviewing recipes:
1. Press and hold the upper right hidden switch ®
until the display reads UNITS. Release the switch,
then press and release switch until the display
reads REVIEW RECIPES.
P2360
2. Press YES to proceed. The display should now
read NO-NAME LEFT, along with MODIFY, SHOW
and NEXT.
3. Press and release SHOW. The screen will scroll
through all the brew settings for that particular
coffee fl avor name. When fi nished, the display
will return to the coffee name just viewed.
4. To see settings again, press SHOW. To advance
to the next coffee fl avor name, press NEXT.
5. To exit, press NEXT until the display reads THAT
WAS THE LAST RECIPE.
6. After 5 seconds, the display will return to the
REVIEW RECIPES screen. Press and release NO
to advance to the next function screen, or press
and release either ON/OFF switch located on the
front switch panel to exit the programming mode
and return to the MAIN SCREEN.
PROGRAMMING THE BREWER (cont.)
REVIEW RECIPES?
NO YES
MODIFYSHOWNEXT
THAT WAS THE
LAST RECIPE
NO-NAME LEFT
MODIFYSHOWNEXT
EXIT TO
NEXT FUNCTION
SCREEN
SCROLLS THROUGH ALL
BREW SETTINGS FOR
NO-NAME LEFT
COFFEE NAME
SCROLLS THROUGH ALL
BREW SETTINGS FOR ANY
OTHER COFFEE NAMES
STORED IN BREWER'S MEMORY
SCROLLS THROUGH ALL
BREW SETTINGS FOR ALL
COFFEE NAMES IN MEMORY
WHEN IT REACHES LAST
RECIPE IT WILL ADVANCE TO:
35058.1 071205