Brother HL-5280DW - Manual (Page 93)

Wireless installation in ad-hoc mode (HL-5280DW only)
10 - 14
10
9
Choose I’m not able to connect my device to my
access point with a network cable. Click Next.
10
If you are using a wireless computer, choose This
PC has wireless capability., and make sure I am
using an access point in infrastructure mode is
not checked. Click Next.
If you are using a wired computer, choose This PC
uses a network cable to connect to the wireless
network., and you must configure the wireless
settings from the control panel. Click Next and follow
the on-screen instructions to complete the setup.
See Using the control panel NETWORK menu to
configure your wireless network printer (in
infrastructure mode) on page 3-6. When finished, go
to Installing the printer driver on page 10-20.
You need to temporarily change the wireless
settings of your Macintosh
® . Please follow the
on-screen instructions. Please make sure you take
notes on all the settings such as SSID or channel of
your Macintosh
® . You may need them when if you
want to restore the current settings in future.