Brother HL-5280DW - Manual (Page 60)

Control panel setup
8 - 2
8
Control panel NETWORK menu table and default factory settings
(HL-5270DN)
See (HL-5280DW) on page 8-3 for the HL-5280DW NETWORK menu table.
1. The factory setting for IP Address may be changed by the APIPA setting.
2. The factory setting for Subnet Mask may be changed by the APIPA setting.
Level one Level two Level three Options 1 Factory settings
NETWORK TCP/IP TCP/IP ENABLE =ON, OFF =ON
IP ADDRESS= [000-255].[000-255].[000-255].
[000-255] [169].[254].[001-254].[000-255] 1
SUBNET MASK= [000-255].[000-255].[000-255].
[000-255] 255.255.0.0 2
GATEWAY= [000-255].[000-255].[000-255].
[000-255] 0.0.0.0
IP BOOT TRIES =0 to 32767 =3
IP METHOD =AUTO, STATIC, RARP,
BOOTP, DHCP =AUTO
APIPA =ON, OFF =ON
IPV6 =ON, OFF =OFF
NETBIOS/IP - =ON, OFF =ON
ENET - =AUTO, 10B-HD, 10B-FD,
100B-HD, 100B-FD =AUTO
FACTORY RESET OK? - -