Belkin High Speed ADSL2+ Modem F5D5730au - Manual (Page 19)

35 34
Manually Configuring your Modem Manually Configuring your Modem
35
se
ct
io
n
2
1
3
4
5
6
7
Click Add or Edit to display the following page and add a new static
route to the list.
Parameter Description
Index Displays the number of the route.
Network
Address Enter the IP address of the remote computer for
which to set a static route.
Subnet Mask Enter the subnet mask of the remote network for
which to set a static route.
Gateway Enter the WAN IP address of the gateway to the
remote network.
RIP Parameter
The device supports Routing Information Protocol (RIP) v1 and v2 to
dynamically exchange routing information with adjacent Modems.
Parameter Description
RIP mode Globally enables or disables RIP.
Auto summary If Auto summary is disabled, then RIP packets will
include sub-network information from all sub¬net
works connected to the ADSL Modem. If enabled,
this sub-network information will be summarized
to one piece of information covering all sub-
networks.
Interface The WAN interface to be configured.
Operation
Mode Disable: RIP disabled on this interface.
Enable: RIP enabled on this interface.
Silent: Listens for route broadcasts and updates
its route table. It does not participate in sending
route broadcasts.
Version Sets the RIP version to use on this interface.
Poison Reverse A method for preventing loops that would cause
endless retransmission of data traffic.