Troubleshooting – Belkin F1UP0001 User Manual

Page 45

Troubleshooting

“Subnet warning” error screen appears during setup

The subnet warning is generally associated with the existence
of more than one network in the area. Subnet warnings occur
when the Print Server has an IP address from one network
domain, and the computer is on another network domain. The
best solution in this case is to connect the Print Server to the
network using an Ethernet cable and to configure it using the
Setup Wizard. Then, after it has been configured into the correct
subnet, disconnect the cable, and then reattempt the wireless
setup using the Wizard.

If the Print Server has been configured before, and the IP address
has already been set to another subnet, the best solution is to
restore factory defaults on the Print Server. Do this by holding
down the reset button while repowering the Print Server. After a
reset, the Print Server will generally receive an IP address in the
correct subnet.

“No printer” error screen appears during setup.

In most cases, this error occurs when the printer is not powered
on, or it is not enabled (or online). After you have checked this,
make sure that it is not out of paper or jammed. Some printers
“sleep” after periods of inactivity. In any of these cases, restore
the printer to functionality, then, if necessary, reboot the Print
Server. Some USB printers are not compatible with Print Servers.
To check the Belkin website for compatibility information, go to:
http://web.belkin.com/support/F1UP0001.

P74496uk_F1UP0001_man.indd 43

20/7/04 12:53:39 pm